ICOM IC-7100 programming banks

I am new to the IC-7100, and the CS 7100 Cloning Program. I have used the program a couple times in the last few days updating stuff on my radio, and all is OK so far except programing the Memory Channels. It list B01 - B99, C01-C99, D01-D99, and E01-E99 in the program. I put all the analog 2m repeaters in the A bank, and was going to put 440 in B, and 6m in C bank, but after putting the in a 440 repeater in one of the B slots, it did not load into the radio.

Are these supposed to work like the A bank? These are the Memory Channels, not the Digital Repeater list section.



Amateur Radio Users Support Group

AmateurRadio@groups.io
https://groups.io/g/AmateurRadio 





Icom IC-7300 SDR Transceiver
https://groups.io/g/icom7300




Labels: , , , , , ,

1 comment:

  1. Douglas1/21/2016

    Did you save the settings to the correct program file for your radio prior to uploading to the radio? I have edited the program list and forgot to save the file prior to uploading to find my upload was identical to the last upload :P 73's

    ReplyDelete

.
Thanks for your comments, Comments may take a day to show up

Amateur Radio Users Support Group
https://groups.io/g/AmateurRadio

ICOM IC7300 IC-7300 SDR Transceiver
icom7300@groups.io
https://groups.io/g/icom7300

Icom 7610 Transceiver
Icom7610@groups.io
https://groups.io/g/Icom7610
.

Note: only a member of this blog may post a comment.

Subscribe to: Post Comments (Atom)